Tube brush IBU dia. 6.6x25 mm shank dia. 2.9 mm aluminium oxide filament dia. 0.30 grit 600

Technical information

Tube brush IBU dia. 6.6x25 mm shank dia. 2.9 mm aluminium oxide filament dia. 0.30 grit 600

Dia. external: 6.6 mm
Dia. filament material: 0.3 mm
Dia. shank: 2.9 mm
Filament material: Aluminium oxide (AO)
Grit size: 600
Length, total: 5
Length, total: 125 mm
Max. RPM: 1000 RPM
Mounting system: Shank
Width: 25 mm
Packaging unit: 10 pieces

Description

For light deburring, cleaning of holes and cross holes and for work on surfaces.

Brushes with aluminium oxide (AO) are less sharp-edged and aggressive compared with SiC. They are primarily suitable for polishing and smoothing finishes on soft metals.

Plastic filament withstands temperatures up to 220 °C.

Advantages

Enable maximum precision and efficiency in work on delicate workpieces.
Highly flexible, enabling optimal adjustment to the workpiece contour.
The dimensional accuracy of the workpieces remains unchanged.
With tube brushes with a short eyelet, the filament reaches up to the tip of the brush.
The bent end of the wire does not have any sharp edges, which prevents delicate surfaces from getting scratched.
Abrasive grains are embedded in flexible plastic filaments, which means that the filament works on the sides as well as at the tip.

Recommendations for use

Please observe the recommended rotational speeds.
Use with clockwise rotation.
Use coolant for applications where large amounts of heat are produced.

Safety notes

For safe use, guide the brush into the workpiece before commencing any work.
When clamping the brush, ensure that the shank is clamped as far into the arbor as possible. This applies in particular for use in the high rotational speed range. The minimum clamping length is 10 mm.

Materials that can be worked: Aluminium; Bronze; Cast iron; Cast steel; Cobalt-based alloys; Other non-ferrous metals; Steel, cast steel; Steel materials with a hardness > 54 HRC; Steels up to 1,200 N/mm² (< 38 HRC)

Applications: Cleaning; Deburring

Drive types: Flexible shaft drive; Manual application; Power drill

Downloads

Tube brushes, micro-abrasive, shank-mounted

Tube brush IBU dia. 6.6x25 mm shank dia. 2.9 mm aluminium oxide filament dia. 0.30 grit 600

PFERD Newsletter subscription