Tungsten carbide burr set for high performance, cut STEEL

Tungsten carbide high-performance burr set 1807 STEEL 3-piece dia. 12mm shank dia. 6 mm for steel

SET 1807 STEEL 3TLG

Item number:: 21901807
EAN:: 4007220431528

Tungsten carbide high-performance burr set 1807 STEEL 3-piece dia. 12mm shank dia. 6 mm for steel 1

Tungsten carbide high-performance burr set 1807 STEEL 3-piece dia. 12mm shank dia. 6 mm for steel 2

Tungsten carbide high-performance burr set 1807 STEEL 3-piece dia. 12mm shank dia. 6 mm for steel 3

Tungsten carbide high-performance burr set 1807 STEEL 3-piece dia. 12mm shank dia. 6 mm for steel 4

Tungsten carbide high-performance burr set 1807 STEEL 3-piece dia. 12mm shank dia. 6 mm for steel Youtube

Technical data Change variant

Technical information

Tungsten carbide high-performance burr set 1807 STEEL 3-piece dia. 12mm shank dia. 6 mm for steel

Cut: STEEL
Dia. shank: 6 mm
PFERD type: 1807 STEEL
Packaging unit: 1 piece

Description

Set 1807 STEEL contains three tungsten carbide burrs for processing steel and cast steel in the most common shapes and dimensions. The sturdy plastic box protects the tools against dirt and damage.

Advantages

Up to 50 % higher stock removal rate when used on steel and cast steel in comparison to conventional cross-cut burrs.
Tangibly more aggressive, large chips and very good chip removal through the innovative tooth geometry.
Workpieces are protected through significantly lower thermal load.
The highly accurate concentricity enables impactfree working without creating chatter marks and the drive is subject to less wear.

Recommendations for use

To prevent vibrations, place the tools on powerful drives with an elastically supported spindle wherever possible.
Observe the recommended rotational speeds.

Safety notes

The very high stock removal rate can cause discolouration on the shank. This does not constitute a safety risk.

Materials that can be worked: Case-hardened steels; Cast iron; Cast steel; Hardened, heat-treated steels over 1.200 N/mm² (< 38 HRC); Steel, cast steel; Steel materials with a hardness > 54 HRC; Steels over 700 N/mm² (> 220 HB); Steels up to 1,200 N/mm² (< 38 HRC); Steels up to 700 N/mm² (< 220 HB)

Applications: Cutting out holes; Deburring; Leveling; Milling; Milling out; Surface work; Work on weld seams

Drive types: Flexible shaft drive; Robot; Stationary machines; Straight grinder; Tool machine

PFERDVALUE

PFERDEFFICIENCY

recommends burrs with the STEEL cut for working for long periods with low levels of fatigue, whilst saving resources and achieving perfect results as quickly as possible.